Ice Fishing => General Discussion => Topic started by: holehopper on January 07, 2016, 03:48:42 PM
Title: Getting Ready
Post by: holehopper on January 07, 2016, 03:48:42 PM
Today I finally felt motivated enough to start getting my gear together for the upcoming gala extravaganza (ice) up till now,not so much,so I relined 5 reels,dug out the boots,boot dryer,heater,propane tanks,organized the jig box (again)took cover off shanty,etc.etc.you get the picture,so most of my ducks are in a row,and blazing at the bit to get out there and have at it. :D
Title: Re: Getting Ready
Post by: toadfish on January 08, 2016, 05:28:42 AM
I still don't have my stuff ready yet. Shanty will come out of the attic this weekend while the rain is falling. Rods and reels are nearly ready. Need a new rod for my Christmas straight line reel, to be ordered soon. Will get lantern out and make sure it is OK. Both 5" lazer and 7" mora augers are eager to drill some holes. Vexilar battery is charged and ready.
My clothing was prepared at the end of last season. It needs one last check before starting this one. Also checking the life picks to make sure they are still in the parka.
Title: Re: Getting Ready
Post by: icebucketjohn on January 08, 2016, 06:21:02 AM
Sorry to say, but most of my gear has been ready since mid November.
Title: Re: Getting Ready
Post by: 30inthabucket on January 08, 2016, 06:21:30 AM
I'm pretty much ready. Been fishing the docks some so the reels and tackle are good along with the lowrance. Finally got the runners on my shanty last weekend. The augers and spud bar are still hung up in the garage attic but that will only take a min to get down. Just need to check all my safety gear. And get some ice to walk on
Title: Re: Getting Ready
Post by: g on January 08, 2016, 08:33:11 AM
Use my ice gear, except shanty, auger and safety gear, year round so I am good to go. May do a few mods to the shanty but it is usable as is.
Title: Re: Getting Ready
Post by: Downthehole on January 08, 2016, 08:39:14 AM
I'm ready, going to put runners on my sled this weekend.....good to go!
Title: Re: Getting Ready
Post by: snowcone on January 08, 2016, 11:45:50 AM
I know my stuff is on the launch pad, even my boat can roll in an hour, so both are sitting there with the fuse burning and I even have frozen emeralds just in case . I just have a hard time with this lull .
Title: Re: Getting Ready
Post by: holehopper on January 08, 2016, 03:35:00 PM
yeah,the in between time is the worst. >:(
Title: Re: Getting Ready
Post by: slabslayer on January 09, 2016, 07:41:53 AM
I'm ready too. Shanty is all set up in the basement. Just have to put line on one of my tear drop reels and I'm 100% ready. Soon as we have ice I'll put the shanty in my truck and be ready to go.
Title: Re: Getting Ready
Post by: icebucketjohn on January 09, 2016, 08:11:29 AM
Decided it was time to get rid of the rubber bungy strap style blade portector on my auger. (It's way too easy to slice your fingers while trying to take it off or put it back on.
Just ordered: Ice Armour Auger Blade Cover.
Comments from experienced users?
Title: Re: Getting Ready
Post by: snowcone on January 09, 2016, 08:58:12 PM
does it have a bungee also ?
Title: Re: Getting Ready
Post by: Downthehole on January 11, 2016, 06:18:15 AM
I put the Hyfax runners on my sled yesterday. We had snow in Powell so I was able to test it. The 100lb'ish sled pulls easily over snow and even easier over what bit of ice we had in the neighborhood. I was surprised when pulling it over concrete - not too difficult. My gear is packed so I'm ready....
Title: Re: Getting Ready
Post by: icebucketjohn on January 11, 2016, 02:00:25 PM
HOLEHOPPER GARY: HAVE YOU DONE A 'DRIVE BY' TO CHECK ON NIMMY LATELY?
Title: Re: Getting Ready
Post by: holehopper on January 11, 2016, 02:15:58 PM
No,sorry,I have 2 buds who live in the area,and they will keep me posted when it's time,might go for a look see on wed.now worried about warming temps.and rain forecast.