Fished today from 9:00 till 2:00 . Marked some nice schools that came through and didn't slow down !!! Did manage to pull 2 cats today one on a homemade jawjackers and a minnow and the other came on a good vibe that I thought was tangled so I set it down to jig the other rod and I looked at it about 20 seconds later and it was on . Just a plain gold vibe without being tipped ...... Fished out of grand view ramp off the point to the left in 14 fow

Wondering if anyone has fished Huron or cranberry creek ? Not felling up to a 2 mile walk and was wondering if there was any fish being caught closer to shore ? Never iced at erie and any help would be appreciated !!

Fished today straight out from state boat launch . Fished in 10 , 14 and 17 fow ..... Not a nibble . Marked fish all over the screen but no takers . Tried everything and no luck at all . Having a hard time finding anything through the ice on this lake

So with the ice thick as heck .... I decided to make an adaptor for my 6 inch hand auger .  A piece of pipe inside , drilled hole for bolt , welded a 3/8 clue is pin on the end to attach to the drill ...... Tried it with my cheap craftsman 18 volt drill last week and it was a dud ! Brought home the 18  volt dewalt hammer drill . Went out to moggy and tried it again ..... 11 inches of ice ....... 7 seconds clean hole !!!! Need to pick up a dewalt !

 .   Ok all I am new to ice fishing and found out at mosquito Sunday that a gas auger is almost as important as the rods !!! I did not have one and seen people using. Them and after getting 2 holes drilled by hand and I look over and the guy next to me has his drilled and is already fishing . So if anyone has one cheap enough like really cheap I am interested . If it needs some work that is fine. For I am mechanically inclined . Don't care what it looks like as it drills holes . You can PM me you post in this thread . Thanks all !!

I'm in with a partner!!

Ok who won or was there no walleye caught ?

Thanks slab , think I might be there